Ну это не принципиально, для чего они это позиционируют. Пусть даже так. Однако, диаметр 0.117, разрывная 7 лб, удельный вес 1.4 и размотка 150 метров очень даже намекает на то, для чего их надо у нас использовать. Тем более, что похожую фуджино я уже попробовал, купив за 4500р в одном из наших магазинов. А то PE-шки раздражают своей медленнотонучестью на дальних дистанциях и/или больших глубинах.
Я так себе представляю, что это "бомба" на особо дальних дистанциях, когда не надо через "засады" продираться. Жаль лишь, что на ебее она не присутствует, а то цена 5800 йен за 150м при этих параметрах очень даже вкусная.
По поиску в Японии она много где попадается. Ну и в помощь тебе часть инструкции, чтоб развеять кое какие сомнения.
141 sinker Ajingu technical advice technical advice
This time, the purchase of 141 sinker Ajingu, Thank you very much. This line, since the PE line and the material is different, the following number of the time line using
We take into the consideration of the points, it will line performance when it is your is kept relatively long.
1. You can not stop writer of yarn end is (it will become high when burn), but allows the use of instant adhesive. With many put too, because becomes hard, Go
When it is used, there is a very small amount is sufficient effect.
2. We are subjected to a coating on the surface, but by the friction of the top guide, the thread fuzz is likely to occur.
When you have pulled the fish from the water surface is not wound the reel, such as taking in with a shock leader, the risk of rubbing against a guide in a state in which the weight of the fish took 100%
By reducing, to suppress considerable fuzz, you can keep durability.
3. Badly fuzzy place, because there is a risk of reduction in strength, it is recommended that you get to use it to cut that part.
4. Fishing after please use the spray if necessary to drop the salt. If you leave remained salt, salt crystallizes, it may cause to put scratches the yarn.
5. When unity is the point that you do not overtighten the areas of Cobb. For there is no growth material, as weak and in broken wire, the strength of the fiber is broken part
Degree is especially reduced. Not that you fall out and slipped to as PE, please pay attention to not tighten more than necessary as long as it tightened.
6. as an emergency measure when the yarn is fluffy, by attaching the instant adhesive to that part, to prevent the spread of fuzz fibers and suppressed the reduction in strength.
However, since tends to be hard, please note.
7. Recommended knots with shock leader, FG knot or Triple Eight knots. Other as reference, [double leader] Introduction.
Prepare a thick No. 2 to 2.5 issue about the line about 40cm ~ 50cm, unity in Ajingu line and FG knots (fewer collapse thread of Ajingu line), and then to use the original and the line (for example,
The unity of the 1 to about No. 1.5) and shock leader in double or triple eight knots as. In this way, a double or triple eight knots also when replacing the shock leader
Because it is replacement only, it is convenient.